Sveriges forum och mötesplats för basister
https://www.pratabas.se/
Jag personligen skulle nog för lägsta möjliga latency satsa på ett UA-kort och köra UA-pluggar så långt det går. Alternativt en Apogee GiO.A good strategy for finding the optimal combination of settings is to start at the top of the Advanced Audio Settings panel and work your way down. To start, leave the I/O Safety Buffer off and keep the Driver Latency slider to its right-most and maximum setting:
Load the most CPU intensive patch you intend to use when you perform.
Determine the lowest I/O Buffer Size you can use without any audio dropouts or glitches. Keep in mind that this is influenced not only by the processing power of your computer, but by the type and number of plug-ins and simultaneous number of channel strips you use.
If the lowest I/O Buffer Size setting you can use gives too much latency for you to perform comfortably, try setting it to the next size lower and enable the I/O Safety Buffer.
Once you have determined the best buffer settings, try lowering the Driver Latency setting to further reduce the overall latency of your system. Since the primary factor determining the lowest possible setting is your Core Audio driver, it is a good idea to revisit this setting if you change to a different audio interface or install an updated driver for your current interface.
